1. Welcome to CAST's newly designed and improved Forum

    Log in or Sign up and share the knowledge!

    Dismiss Notice

Bug with Report Rigging Points

Discussion in 'Technical Support' started by Tusiek, Jan 24, 2020.

  1. Tusiek

    Tusiek New Member

    Joined:
    Jan 4, 2019
    Messages:
    2
    Likes Received:
    0
    I have a problem with Reporting Rigging Point
    On a left is CAD view of point with correct position
    on a right is Report view of position Rigging points
    is not the same, the problem is when i use user origin of 0.0 point
    when i dont use user origin is working corretly
     

    Attached Files:

  2. Dany

    Dany Administrator
    Staff Member

    Joined:
    Jan 16, 2014
    Messages:
    846
    Likes Received:
    91
    Apologies for the EXTREMELY late reply here.. I clearly missed this post.

    I just looked into this though, and it only happens after the User Origin has been changed from within PRES Mode (i.e. via the OPTIONS menu > Document Options > Draw Defaults tab). (This is seldom done.. if a User Origin change is required, it is normally performed in CAD mode.) After clicking OK, Reports are refreshed correctly, but CAD Item(s) are unfortunately not -- and even right-clicking on it/them and choosing Refresh does not update the coordinates correctly. The workaround is easy however: double-click on the CAD Item(s) to open them, and then close it/them right away.


    Cheers,

    Dany
     

Share This Page