1. Welcome to CAST's newly designed and improved Forum

    Log in or Sign up and share the knowledge!

    Dismiss Notice

offset in data tab mode

Discussion in 'wysiwyg' started by benzi, May 8, 2014.

  1. benzi

    benzi New Member

    Joined:
    Feb 28, 2014
    Messages:
    8
    Likes Received:
    0
    Hi there
    I have a problem. when I hang fixture on truss, in the data tab mode I don't have the offset of the fixtures.
    does anybody have solution ?
    tnx
     
  2. Dany

    Dany Super Moderator

    Joined:
    Jan 16, 2014
    Messages:
    717
    Likes Received:
    67
    Hi Benzi,

    For the time being it is not possible to show Offsets for fixtures which hang on anything other than Pipes. However, you do have a couple of options here:

    1. Use the ages-old trick of hanging fixtures from Pipes which you either "bury" into the truss so you can get the offset that way.

    2. Instead of using Offset, enable the X columns in DATA Spreadsheets or PRES Reports (and the Y and Z columns if you like) in order to see each fixture's position in space.


    Cheers,

    Dany
     
  3. benzi

    benzi New Member

    Joined:
    Feb 28, 2014
    Messages:
    8
    Likes Received:
    0
    Not working

    Hi Dany!
    I have try but there is no option filtering the x nor y or z
    Tnx benzi
     
  4. Dany

    Dany Super Moderator

    Joined:
    Jan 16, 2014
    Messages:
    717
    Likes Received:
    67
    Hi Benzi,

    Sorry but this is not the case: as you can see in the screenshot I attached here, you can both Sort by the X/Y/Z columns, and apply Data Filters to them...

    X_Y_Z_-_sort_and_filter.jpg


    Thanks,

    Dany
     
  5. benzi

    benzi New Member

    Joined:
    Feb 28, 2014
    Messages:
    8
    Likes Received:
    0
    Hi Dany
    does R30 support x,y,z filtering?
     
  6. Dany

    Dany Super Moderator

    Joined:
    Jan 16, 2014
    Messages:
    717
    Likes Received:
    67
    Sorry, but no; this feature was added in Release 31.
     
  7. Stigrs87

    Stigrs87 Member

    Joined:
    Feb 28, 2014
    Messages:
    15
    Likes Received:
    1
    Is it possible to add the X position to a fixture layout? If this is not possible yet, is it possible to import data from the X column to the note column?
    Like in excell: =a1
     

Share This Page