1. Welcome to CAST's newly designed and improved Forum

    Log in or Sign up and share the knowledge!

    Dismiss Notice

Update plots

Discussion in 'wysiwyg' started by Stigrs87, Feb 19, 2019.

  1. Stigrs87

    Stigrs87 Member

    Joined:
    Feb 28, 2014
    Messages:
    15
    Likes Received:
    1
    Hi!

    Is there a way, or can you please implement an "Update update all plots" in the "PRES -> New Plots" section.
    At the moment i need to go in to every single "New plot" and update it if I have done an edit.. Which i do all the time..
     
  2. ShaunC

    ShaunC New Member

    Joined:
    Feb 26, 2018
    Messages:
    9
    Likes Received:
    0
    That would be a handy feature, especially if you use plots heavily. It would also be nice if you could Cycle Selection on Pipe/Truss/Fixtures in Plots. Currently if all your trusses are at the same height in a front elevation you can't select cycle through to separate them!

    Also I think being able to use dimensions in plots would be handy, and linear scales.
    It's likely they don't want to recreate the CAD module in it's entirety but plots can leave you wanting a bit more.
     
  3. Dany

    Dany Super Moderator

    Joined:
    Jan 16, 2014
    Messages:
    698
    Likes Received:
    65
    Very good points, guys! I will pass these suggestions along.
     
  4. sanderloonen

    sanderloonen Member

    Joined:
    Jul 14, 2015
    Messages:
    19
    Likes Received:
    4
    On the subject of Plots, I dont see a way of using selection sets in the New Plots Tab?

    is that correct? or am I just missing something?
    If I am not missing something, could this be made possible?

    thanks

    Sander
     
  5. Dany

    Dany Super Moderator

    Joined:
    Jan 16, 2014
    Messages:
    698
    Likes Received:
    65
    This is currently not possible, but I will add it to the list as well. Thanks!
     
  6. Floriaan

    Floriaan Active Member

    Joined:
    Feb 13, 2015
    Messages:
    279
    Likes Received:
    60
    To add to this: if anywhere cycle selection is useful, it is in New Plots. As we speak I am struggling to move one of two pipes of the same lengths exactly above each other (double F.O.H. house bridge)...
     

Share This Page