1. Welcome to CAST's newly designed and improved Forum

    Log in or Sign up and share the knowledge!

    Dismiss Notice
Jason Gardash
Last Activity:
Dec 5, 2023 at 6:08 AM
Joined:
Feb 5, 2014
Messages:
156
Likes Received:
19
Trophy Points:
18

Followers 1

  1. Elie
Location:
Edmonton, AB Canada
Occupation:
Designer, Operator

Share This Page

Jason Gardash

Active Member, from Edmonton, AB Canada

Jason Gardash was last seen:
Dec 5, 2023 at 6:08 AM
    1. Paul Moss
      Paul Moss
      Hey Jason, it's Moose. I have some questions regarding recommendations for a new pre-vis machine as mine (at 6yrs+ old) is getting a little dated and I have a decent project coming up where I'm being hired to specifically pre-vis. I've posted in the tech support area but was wondering if you had any thoughts?
      Jan 19, 2022
      2. Jason Gardash
        Jason Gardash
        Hey Moose,
        lol yea. I will say wyg in office computers are older. they don't officially have a GTX card yet. (shhh I didn't say that out loud)
        I'll send you a message via FB as I'm on there more than here.
        I can give a fair bit into specs for pre - viz since I basically just do that now. and the whole MVR GDTF thing. and helping Dany intergrade all that into Wyg.
        Jan 19, 2022
        Paul Moss likes this.
  • Loading...

  • About

    Location:
    Edmonton, AB Canada
    Occupation:
    Designer, Operator

    Interact

    Content: