1. Welcome to CAST's newly designed and improved Forum

    Log in or Sign up and share the knowledge!

    Dismiss Notice

Array Tool on a Circle Truss

Discussion in 'Technical Support' started by Dalight, Apr 25, 2018.

  1. Dalight

    Dalight New Member

    Joined:
    Mar 4, 2014
    Messages:
    5
    Likes Received:
    0
    Hi there,

    I don't know if something is escape but can't use ARRAY ALONG PIPE on a Circle Truss.

    Never used this tool before so I don't know if it is a bug from R40 or this cannot be done.

    Thank You.
     
  2. Dany

    Dany Administrator
    Staff Member

    Joined:
    Jan 16, 2014
    Messages:
    886
    Likes Received:
    104
    It is currently not possible to use the Fixture Array tool with curved truss.
     
  3. Dalight

    Dalight New Member

    Joined:
    Mar 4, 2014
    Messages:
    5
    Likes Received:
    0
    Thanks Dani.
     
  4. DrewAVM

    DrewAVM Member

    Joined:
    Sep 10, 2014
    Messages:
    29
    Likes Received:
    9
    I use a 359 degree curved pipe the same radius as my truss, then either just align that pipe near the truss, or move the fixtures across using the pipe positions as a guide. Rough, but it's a workaround!
     
    Firebrand likes this.
  5. Dalight

    Dalight New Member

    Joined:
    Mar 4, 2014
    Messages:
    5
    Likes Received:
    0
    Hi Drew,

    Thanks for your reply. I did something near that. One half circle, mirror, full circle and then array.
    Sincerely never tried on a circle before but it is a big one and a lot of fixtures.
     

Share This Page